Various timing loops show 11.8 being the average speed of the cpu and this does run true when comparing emulation and real hardware when timing is not based on VSync (ssf2 and ssf2t for example). This problem could be due to the 68k being clocked at 11.8MHz when the hardware has a 16MHz crystal on it. The problem seems to happen due to gfx drawing slowing to much when screen colors fade out. Giga Wing's attract mode seems to loose sync with music. The network adapter used in Super Street Fighter II: The Tournament Battle is not currently emulated though the ports it uses are setup in the memory map. The screen should split into around 6 or more strips and then scroll the gfx inside those strips up and down alternatly (as one stip moves gfx up the next strip moves the gfx down). A known place where this problem happens is during Shuma-Gorath's Chaos Dimension super move in both MSH and MSHVSF. Rasters are not correctly emulated in places where more than one split happens per frame. 17th April 2009: Guru - I had a spare couple of hours today so I dumped the NAOMI title Marvel Vs Capcom 2 (thanks to Heywood Floyd for the cart). Capcom 2 (JPN, USA, EUR, ASI, AUS) (Capcom 2000). So today morning i got an email telling me that the new data was the last piece of the key, so now Makaron fully emulated Marvel Vs Capcom 2 without glitches or so, i finished the game two times in a row and got no issues. 19th August 2009: Alex's Rom Dumping Project - I got an email from Deunan telling me to dump some areas on the Marvel Vs Capcom 2 cart again, so it was arround 3am and i was pretty tired, but i decided to spend some more time, burn an EPROM and dump that data again, so i did and sent it to Deunan (coolest guy ever i have to admint). Capcom 2 (thanks again to Alex) and it boots and runs in MAME. Belmont - Round one: Got the protection hooked up for Marvel vs. Capcom 2 (JPN, USA, EUR, ASI, AUS) (Rev A)'. 0.138u3: Changed description to 'Marvel vs. Capcom 2 New Age of Heroes (JPN, USA, EUR, ASI, AUS) (Rev A)'. 0.142u3: Changed description to 'Marvel vs. 0.142u5: Changed description to 'Marvel Vs. 0.153: Use real chip dump for Marvel Vs. Hyper Street Fighter II: The Anniversary EditionĬapcom Vs. Street Fighter III 3rd Strike: Fight for the Future Street Fighter III 2nd Impact: Giant Attack Super Street Fighter II - The New Challengers Super Street Fighter II: The New Challengers Capcom: Clash of Super Heroes (Japan 980123)' (Testdriver). 0.37b7: Added clone 'Marvel Super Heroes vs. Capcom: Clash of Super Heroes (Hispanic 980123) (Testdriver). Capcom: Clash of Super Heroes (Japan 980112) (Testdriver). 23rd January 2002: Razoola - Released XORs 77-80 for Marvel Vs. Capcom: Clash of Super Heroes (Asia 980112) (Testdriver). Capcom: Clash of Super Heroes (Brazil 980123). Capcom: Clash of Super Heroes (Asia 980123). Capcom: Clash of Super Heroes (Euro 980112)'. Do - I finished off the rest of the instruction cards made available by Strider of Cybercade: Marvel vs. Capcom: Clash of Super Heroes (Euro 980123)'. Capcom: Clash of Super Heroes (USA 980123 Phoenix Edition) (bootleg). 0.128u4: MAMEPlus added clone Marvel Vs. Capcom: Clash of Super Heroes (USA 971222). 0.138u3: Razoola added clone Marvel Vs.
Marvel vs capcom 2 chd files code#
The ROM has been repaired so that the code matches the other sets after decryption.
NOTE: The originally dumped ROM4 (mvce.04a) contains garbage instructions that cause the game to crash during the ending staff roll. 0.142u5: Alex Jackson fixed reset at staff roll only in Marvel Vs. The section in service mode where it normally shows you the volume level is totally missing in this version. The differences I've seen so far are the mask roms are different sizes and the volume is controlled with a knob instead of digital steps. 16th November 2012: Smitdogg - We got the CPS2 single board version of Marvel Vs.
Capcom: Clash of Super Heroes (Japan 980123) (Single PCB)'. 0.147u3: ranger_lennier, Yohji, Tormod, Smitdogg and The Dumping Union added clone 'Marvel Vs. 0.148: Documented an alternative SIMM card configuration for clone (Japan 980123) (Single PCB).
0 kommentar(er)
